What i could suggest is to contact the manufacturer of the dryer and see if there is anything you could do with your problem and if it is a problem that could effect the quality of your dryers function.Have ready the make, model, and serial number, located somewhere on the dryer, hopefully not all the way on the back panel.Best of luck to you.
Why is my dryer putting black stuff on my clothes | yahoo.Dec 18, 2009 answers.Black gooey stuff is a belt going bad and melting or a deposit in the dryer.One time our dryer had a broken bearing, so the drum moved backwards, and some of the clothes went in between the drum and the inside of the machine.It stained it with oil and rust.
I have a lg steam washing machine.Inside the door at the top of the seal is a small orange piece of plastic that answered by a verified appliance technician.I have a small leak which appears to be from the drumfront door seal.I am about to change the front door seal on my.
This happened to my hotpoint and it is called a drum paddle.It does matter cos the clothes get caught in the holes where the paddle goes and they rip.This happened to me.I went on hotpoint website and got some delivered cost me about 20 but they are really simple to fit.Fine if youve got a hotpoint, not sure abouut other makes tho.
Repainting the drum.Remove the plastic baffles from the inside of the drum.Thoroughly sand the inside of the drum with 100 or 120 grit sandpaper.Special care is needed to remove all films and residues that will prevent the new paint from sticking to the drum clean the inside of the drum with a paint thinner such as toluene that wont leave.
I have a kenmore front loading washing machine approx 5 yrs old and it has worked great until yesterday when i noticed several small pieces of plastic in my wash.Found that there are several long plastic pieces inside the drum and one of them seems to be breaking apart.Is the long plastic part a part that can be replaced by me or do i need a service technician.
Things to check for a dryer venting issue.Plastic vent hose collapses easier and collects water.If the dryer cannot rid itself of the excess heat and humidity it will build up inside the dryer drum.This type of build up may cause the dryer to be hot to the touch, sweat, and may increase the drying times.
My repair advice.I removed the damaged felt strips and all adhesive residue from the dryer door face.Then i installed the new felt strips.The plastic glides snapped into place easily on the drum.Reinstalling the door was a simple operation, and the drum fit snugly on the new felt gaskets.
Door cable wp230131 ap6007087 made by whirlpool.Appliance model kenmore 1107358640w my repair advice featured story.Unplug the machine.Remove the.