You can tell that the switch is faulty if the drum light fails to turn off.Replacing the faulty door switch with a new one should get the drum spinning again.The dryer starts, but the drum wont turn.If the dryer starts okay, but the drum wont spin, check out for the following issues 5.Broken drive belt.
It sounds strange cracked timer knobs are a common reason why your dryer wont turn on, especially on ge dryers pull the knob of the dryers timer shaft and look for a crack or some weak point that would keep the knob from being able to turn the timer shaft.
All whirlpool duet dryers have sensor strips in the drum.As your load of laundry tumbles in the drum, it makes contact with the sensor strips so that the dryer can end the cycle when your laundry is dry.If the dryer is not level, the sensing does not work properly, and your drying cycle will end early.This is.
We have a cabrio steam dryer that is less than one year old.The drum stopped turning and will not respond to anything done to the control panel.The door switch does work the light will come on and off when pressing it, and the timers all count down like nothing is wrong.No air blows and the drum will not turn.Any ideas.
Hey folks i have two of the same model dryers whirlpool mod sgds800jq2 ser mp2411286.Bought and installed at the same time.One broke its belt a few months ago, i replaced that, it works now.The other currently has drum that wont turn i replaced the belt right away the old one wasnt broken, but i thought it might be stretched out.
I have a 6 year old whirlpool electric dryer.The model number for my whirlpool electric dryer is gew9200lw1 when i select any of the dryer settings on the touchpad, the appropriate lights light.
Wp dryer showed f01, replaced the control board now the front panel will not light, the interior drum light goes on so i know there is power.I put the old control board back in and the same f01.
Problem drum light not working, bulb ok.Removed 6 screws on panel behind timer, light, buzzer, switches.Lifted back of dryer top then moved dryer top forward and off of dryer.The switch was located above the door.Unhooked wiring plug and took out 2 screws holding in the switch.Installed new switch and repaced bulb.