Felt seal in the back of dryer behind drum is bent over and caused lint to collect and burn.Is the flet seal replaceable.If so how can it be reattached to metal housing is this a common occurance the dryer is less than 5 years old.
Maytag dryer drum glide felt pad replacement 510189.Print content save content.Share skill level.This video provides stepbystep instructions for replacing the drum glide felt pad on maytag dryers.The most common reason for replacing the pad is the drum not spinning smoothly.Answer your questions and help you get back on track.
5 removed drum, scraped old felt from drum 6 glued new felt with a very strong glue nanoglue or gorilla glue, same thing, let it dry overnight 7 secured back inside panel, replaced drum and put dryer back.
Changing a dryer drumdrive belt.Pete august 3, 2012 0 views 10 min read.Back to the drum.Make sure the felt strip in the rear isnt folded under.Rotate the drum by hand slowly and use your fingers or a putty knife or screwdriver to work the felt liner out as it rotates.
Then there was the inner panel that the drum is held in with.4 screws on that, plus 3 holding the bottom of the lint catch ducting.After getting it all taken apart, a couple minutes seperating the rest of the felt glued on from the drum and a couple more gluing the new one on, and it all went back.
Consult the dryers user guide for a diagram showing where to locate its rollers.Youll probably need to elevate or remove the drum to apply grease to the rollers, especially the ones that support the drum at its rear.The website davesrepair.Com recommends placing one or two drops at the front and back.