Hello, i an having the same issue with my samsung dryer.The drum has cracks and a hole in it.It will not spin.I purchased the washer and dryer at the same time and this is completely unacceptable that this would happen with this dryer at all let alone within a couple of years of ownership.
Dryer drum crack after 2 years of normal use.This didnt crack in the middle of the drum.It cracked on the welded points.If the mfg doesnt weld these points correctly, it forms a.
Compatible drum felt seal for kenmoresears 11069822800, wed5500xw0, part number w10521118, kenmoresears 11076002010 dryer 3.6 out of 5 stars 2 33.90 33.90 37.99 37.99.
Dryer drum weld in your dryer.The following information is for all dryers that have a stainless steel drum during the manufacturing process of your dryer, the dryer drum must be welded together.The weld is a result of joining two pieces of stainless steel and is approximately 1.5 on the back and front of the dryer drum.
You can mig weld stainless with 100 argon, but its not the best choice.Given youre attempting to extend the life of a dryer drum, i think youd be okay for what it is.You do want ss wire though.Find some scrap thats equivalent thickness and run some tests to dial your settings in.Probably best to spot tack it repeatedly using argon instead of attempting to run beads.
We are experiencing the same problem with a dlg7301we dryer.Right out to he box makes two thumps per drum revolution.Had the retailers repair man out and he said it was the drum weld and a lot of the lgs have this problem.No fix.Had the retailer replace it with another and the same thing.
Chemical analysis was carried out on the material inspection, according to the requirements of gb7002006, dryer drum thickness 20 mm we use q235 a, 20 mm we use q235 b according to the gbt 29702004 class ii, the range of 60 mm weld edge every board before cutting for.
Step 5 after we attach the wires to the blades we simply insert them into the slots inside the plug housing, and insert the plastic strain relief which is the green plastic thin on the top of the clam shell housing see picture below.The strain relief is important because without it the wires are more likely to come loose when we plug and unplug it from the dryer outlet.